Yuxiang Yxznrc F150 150mm Blade 3D Helicopter

Description: Welcome to the future of rc helicopters. Bind and fly. Direct bind futaba sfhss or add a futaba sbus or spektrum satellite sold separately. The F150 is a direct drive brushless main motor and brushless tail motor fully assembled helicopter. 3s 500mah for power. Just a battery slot on this bird. Included is a fully max 3s 500mah battery to get you going. At the 150mm blade size this is the most powerful helicopter in its class. It does boast a flybarless unit that offers 6g stabilization mode and 3g aerobatic mode. No bluetooth. This unit uses dials on top of the unit to tune tail gain swash gain and swash agility. The only setting recommended to change is the swashplate agility if you wish to make the helicopter respond faster to transmitter inputs. Secondly in your transmitter atv functions you can change your settings to make the tail spin faster, increase your collective for faster response, and your elevator and aileron atvs for faster response. This is how you make the helicopter lightning fast for extreme 3D. If you own OMP, or GOOSKY, you'll notice the units are all the same. Set up the same. Same technology. The flybarless units from all three brands are under license from Yuxiang. The main motor can accept curves from 50% on up to 100%. This is also a powerful bird. The stock settings are suitable for beginners. 3G 6G mode is on channel 5 assigned as gear and should be assigned to a switch. Parts are available in our store and will be for many years to come. I particularly don't sell anything I haven't tested and don't endorse. I have over 1000 flights on each of the yuxiang 3D helicopters sold. Each bird is tested with one flight to ensure there are no issues. I will also be offering factory repair service. I have smoked tail motors. I have damaged the flight control boards. Once a flight control board is damaged any trimming to try to fix the tail not holding smokes the tail motor. To increase longevity as the tail only wanders in hover I rewind the tail motor with special 240c winding wire. Once that is done the tail motor is impossible to damage. For $20 plus shipping I will do rewinds that take an hour to accomplish. I also have Allen cap kits to replace the Phillips head machine screws used. I do not recommend reinstalling them once removed. For removal I use a soldering iron to heat up the metal causing expansion to remove the screws being careful not to melt any plastic. The main motors after a hard crash will develop vibration. The culprit is the main motor bell. The motor manufacturer does not sell bell replacements so a new motor will have to be purchased. External tail esc’s supporting damped light can also be used if desired. The signal point is labeled on the bottom of the esc to solder too. I am a factory representative. I am happy to answer questions. NO RETURNS ACCEPTED. Be sure you know what your buying before you make a purchase. Testing is done to make sure there are no defects once a product leaves the warehouse. If you have an issue or are unsure please ask.

Price: 189 USD

Location: Bristol, Connecticut

End Time: 2024-10-17T19:30:22.000Z

Shipping Cost: N/A USD