Weld-On #42 - Low VOC Acrylic Adhesive (50 ml)

Description: Weld-On #42 - Low VOC Acrylic Adhesive (50 ml)Weld-On 42 is a two-component, clear, medium bodied, reactive acrylic adhesive. It polymerizes by the reaction of Component A (Base Resin) with Component B (catalyst). Weld-On 42 is packaged in 10:1, 50 ml and 230 ml cartridges for use with a two-component dispensing gun and static mixing tip. The adhesive is mixed as it passes though the mixer tip. The mixed product polymerizes at room temperature; joints are usually hard enough for handling in about 4 hours at 70ºF (21ºC). Machining may be done after 24 hours. This product meets Military Spec A-8576C Type III.Substrate RecommendationsWeld-On 42 is especially formulated to bond acrylic, including extruded cell cast and continuous cast, as well as, molded parts and some cross-linked sheet. It will also bond acrylic to polyester, cellulose acetate butyrate, polycarbonate and other materials.Bonding RecommendationsWeld-On 42 is recommended for bonding of acrylic plastics especially where good clarity retention is required. It is versatile having many applications in the sign industry and in the manufacturing and repair of aquariums, museum quality cases and other plastics fabrication industries.Directions for UseAlways wear safety glasses and disposable polyethylene gloves.Load cartridge into adhesive dispenser and remove nose plugs from the cartridge by unscrewing the retaining nut.Dispense a small amount of the resin and catalyst from the cartridge by depressing the trigger. Make sure both materials flow freely from the cartridge, checking for any blockages. Place the mixer tip on the cartridge and secure the remaining nut. Discard the first 6-12 inches of the material and proceed.IF THE MATERIAL IS NOT COMPLETELY USED WITH ONE APPLICATION, IT CAN BE PRESERVED. Leave the mixer tip in place and its presence will temporarily reseal the cartridge. To restore the cartridge to its original state, remove the used mixer tip, clean the threaded areas thoroughly ensuring there is NO crossover of the two components. Remove any blockages that may have formed in the nose area. DO NOT FORCE BLOCKAGES BACK INTO THE CARTRIDGES.Always use a new mixer tip. Never attempt to force material through a blocked opening or a used mixer tip. Discard the first 6-12 inches of material whenever a new tip is used.Shelf LifeKeep away from sources of heat, open flame, sparks and sunlight. Storage near the ceiling in a warehouse (without air-conditioner) is not recommended. One year shelf life is expected when stored in a cool 50° – 80°F (10° – 27°C) dry place.

Price: 60.2 USD

Location: West Nyack, New York

End Time: 2025-01-28T17:41:56.000Z

Shipping Cost: 5 USD