Veneer Stone Rubber Mold for Concrete or Plaster, Western Quick Fit Flats

Description: Professional grade rubber mold to make easy-to-install stone veneer panels in a stacked stone style that will last for hundreds of pours, created from natural stone to reproduce the natural stone's finest detailsNo release agent necessary, saving you money, time, and clean up, as well as easy, clean release of face color pigments, unlike plastic molds, urethane molds, and silicone moldsMade in the USA from plastisol rubber, including recycled plastisolWestern Quick Fit molds create stones approximately 3.75" wide and in lengths of approximately 19.25", 11.5", and 7.5" for easy installation, with unique stones in each of the 5 versions available for purchase, no stone repeatsMatching Western Quick Fit corner molds are also available Stone Master Mold's manufactured stone veneer rubber mold in Western Quick Fit is ideal for making your own veneer stone for any indoor/outdoor project where stone cladding is needed. Western Quick Fit is a panel stone mold that will create dry stack stone panels that are all approximately 3.75" wide, and in lenghts of approximately 19.25", 11.5", and 7.5" for quick and easy installation. The finished product/stone is approximately 1-1.5" thick. Each mold is approximately 21.5" in length by 20" wide by 2" deep and makes approximately 2.2 square feet of dry stacked stone. Manufactured Stone Basic Mixing Procedures Using A Pre-bagged Concrete Mix: This is one suggestion for mixing the concrete for manufactured stone. There are many other instructions available online, including videos. BE SURE TO USE A CONCRETE MIX THAT CONTAINS PORTLAND CEMENT. We recommend Sakrete Maximizer, as it has lightweight aggregate, is high strength, and yields more product, but there are many kinds you can use. Follow the manufacturer?s instructions for mixing. If using pigment, add desired iron oxide pigment to mixer (100% pure, no additives). These can easily be found on Amazon, etc. A plasticizer can be added to reduce the amount of water in the mix. Pour into the molds which may already have coloring additives? NO RELEASE AGENT NECESSARY. Vibrate molds to release air bubble. Cure in the molds for approximately 24 hours at the minimum of 70 degrees Fahrenheit before demolding. Higher humidity is desired. Molds can be covered with a tarp to retain more heat and humidity. Continue to cure demolded stones at 70 degrees or greater until ready.

Price: 132.95 USD

Location: Kansas, Oklahoma

End Time: 2023-12-06T17:49:29.000Z

Shipping Cost: N/A USD