The ORIGINAL Dremel tool holder 1/4 in. straight shank for your lathe!

Description: DTH-.25 "A-LEE-SAM"$24.99 MADE FROM 1/2" THICK ALUMINUM PLATE! This unique metal lathe tool accessory will allow the home shop machinist, model builder, gunsmith, custom Cue maker, (Billiards), etc. to be able to utilize their Dremel® tool, (or other moto-tool), on their mini metal lathe's 1/4 inch tool holder, (3/8 inch also, using a .125 shim), and be able to precisely control it's movement! Either 3/4" x 12, 3/4" x 16 tpi or M18-1.5mm with counterbore. Check the thread of your Dremel® FIRST, and then choose the correct thread in the drop down list.Made from 1/2 inch high strength aluminum alloy, with a 1/4 inch tall shank and tapped. By placing the 1/4 inch shank in your tool holder, you will be able to use your Dremel® tool as a cut-off tool to very precisely cut your bolts, screws to length! Great for the pen turner who wants to trim the brass inner tube or make his own tubes from bulk tubing! Custom cue makers have found this to be a great item! Precise grinding can be achieved by using the many sizes and profiles of grinding stones, discs etc. on the market while in your lathe's compound. Placing off-center holes in your projects while held in your lathe's chuck and using a drill bit in the moto-tool is easier than moving it to the drill press and having to do a set up again!SEE PIC #1 FOR ACTUAL TOOLHOLDER, other pictures are of our DTH-01 model for a 1/2 inch tool holder but the set up and use is the same.Most modern, (post 1983), Dremel models have ¾ X 12 tpi ! About the only ¾ X 16 tpi models are as follows… Dremel model #’s - #270, 370, 380 ALL are ¾ X 16 tpi Ryobi model HT20vs is also ¾ X 16 tpi Black and Decker, Craftsman and Alltrade so far seem to be all ¾ X 12 tpi. WEN 2305 and maybe other modern models - 3/4 X 12 tpi (Older WEN may be M18-1.5mm)

Price: 24.99 USD

Location: Lima, New York

End Time: 2024-04-02T21:02:34.000Z

Shipping Cost: N/A USD