Pair of 3" X 5" inch 16 ohms ONK 583508-1006 full range ALNICO speakers

Description: FULLY TESTED! Nice pair of vintage radio TV speakers. Size is 3" X 5". Brand is Onk and model is 583508-1006. Thickness is 1 3/4". Crosshole measurement is 4 3/8 inch to 4 5/8" c/c. These speakers could be from the 1980s to 2000s. Typical output rating is from 2 to 5 watt and have a 16 ohms load impedance. It delivers a nice full range sound. Shipped carefully package in a box. Package weight is 14oz. I have this speaker and a lot of other vintage speakers now listed (or to be listed soon), in hand for more then 25 years and up from working in electronic since early 1980s. Check out my other vintage speaker drivers and various items on sale in my store. FULLY TESTEDAll my Speaker drivers are tested with music at the proper impedance setting using a multiple impedance output PA amplifier from radio shack and a FLAC music player on AUX. My criteria is simple, to hear a nice clean sound with no distortion or scratchy sound due to defective voice coil or impurities accumulated on magnet, or due to any cone issues. The type of sound a driver delivers is not considered in the analyse as there are many types of sound depending of many construction aspect (IE: less bass/treble) and it's uses. One of the photos with listing may show the driver under test (if there are wires connected). SP-211 SHIPPING TO USA FROM CANADA: Using USPS ground advantage service via forwarder(exclude Hawaii & Alaska)SHIPPING To CANADA varies by provinces. Please contact me for quotation, thanks. IMPORTANT INFORMATIONwhen ordering a replacement speaker: If you're looking for a replacement speaker, the first important thing to look for is the size in length. If you want to replace a 4 inch speaker in a device, look for this size first and shape type (round, square). See as well the measurement of the fixation holes (when equipped) as it have to be re-installed properly. Then the 2nd important data is the impedance. If it's 4 ohms, look first for a 4 ohms. If none available, choose 3.2 ohms or 6 ohms at max but ideally, use the same impedance (not 8 or 16 ohms to replace a 4 ohms). 3rd, it's watt output rating. This is not a must in some case, mainly for a TV or a Radio replacement speaker but the nearest value will give the best result. Don't choose either too low (it may fried the speaker coil) or too high (speaker will not vibrate enough). A 1 to 2 watt speaker would be fine to replace a 1 Watt speaker for example. And finally, it's thickness. This will be an important factor when the speaker is located in a restricted area. If you have 2 inches available, then go below this measurement to be sure it will fit.

Price: 19.99 USD

Location: Beebe Plain, Vermont

End Time: 2025-01-24T18:52:17.000Z

Shipping Cost: N/A USD