Hydraulic Solenoid Valve D05 31GPM 4560psi 110VAC Soft Shift (Compactors Balers)

Description: Soft shift valves shift 3-5 times slower than standard valves to reduce shock in the hydraulic system and reduce the in-rush current. The shift times are still fast enough to barely effect the machine performance.Commonly used in balers and compactors.Compare to: Nachi SS-G03-___-FR-E115-E….To order the valve D05 subplate got to eBay link: https://www.ebay.com/itm/165628975957Terminal box with 1/2" conduit connection.110VAC D05 (NG10) Cetop mounting. Can be mounted to standard available subplates and bar manifolds.Maximum flow of 31 gpmMaximum working pressure = 4560psi (315 Bar)3-position, 4-way, Spring centered, energize to shiftDouble solenoid operatedSolenoid Power: DC= 35 watts, AC = 90VA (550VA inrush)Operating temperature = -22֯F to 174֯FValve can be mounted in any directionCoil can be rotated to optimal connector positionLED illuminate’s clear connector housing when power is supplied to the connector/coil. NBR Buna sealsUse with mineral based hydraulic fluid.Four fastening screws included, M6x40mm longWhite label with no logo for OEM manufacturers.Spool Configurations:C: Closed center spool, all ports blocked when centered. Useful to switch actuator directions and to fully stop cylinder or motor when centered. Make sure there is a relief valve to protect overrunning loads from spiking the pressure during sudden stops when centering. Note that there is a small amount of oil leakage across any spool type valve manufacturer for smooth shifting. This means there could be slow drifting of the actuator in the center position. Use a Pilot Operated Check Valve series VMCP6 with the M Valve spool type if you need to hold position over a long period of time. M: Motor spool, A and B ports to tank and P port blocked when centered. Actuators will move freely from external forces when the valve is in the center position. Motors and cylinders will coast to a stop when centering. Adding an A&B port P.O. check valve under this valve will ensure a positive stop and hold the position of a motor and cylinder for longer durations than with just a closed center spool valve C. T: Tandem Spool, A and B ports closed and P to T in center position:Actuators will stop in center position and the supply pressure will be directed to tank. Commonly used with fixed displacement gear pumps so pressure can flow direct to tank and not build up heat by blowing across a relieve valve as would be needed with the M and C spool. H: Open Center Spool, A, B P and T ports connected in center. Actuators will freely move when valve is de-energized and spring centered. Pressure and all ports will drain to tank. Energize solenoid “a” and “b” to change direction of actuator. High volume OEM series production available per request.

Price: 174 USD

Location: Milwaukee, Wisconsin

End Time: 2024-10-10T20:13:15.000Z

Shipping Cost: N/A USD