For Raspberry Pi Zero W 0W 2W 3B+ 4B 4B+ Duplex MMDVM Hotspot Board UHF VHF

Description: Product Description If you have any questions, please contact customer service first, do not open disputes easily, thank you! Features: Supports DMR, P-25, D-Star and System Fusion Fully tested Onboard LED to show status (TX, RX, PTT, Mode) SMA antenna connector, antenna included Mounts cleanly on all current Raspberry Pis including the Pi Zero w /2W WIDELY COMPATIBLE: Supports DMR, P-25, D-Star and System Fusion WORK with RASBERRY Pi: Mounts cleanly on current Raspberry Pi including the Pi Zero w /2W Mode: Support both Duplex mode and Simplex mode Differencs in Duplex and Simplex:in Duplex mode,have 2 time slots, and Tx and Rx can do at the same time Radio Frequency : in duplex mode,support uhf 430-440MHZ, in simplex mode support both uhf 430-440MHz and vhf 140-150MHz Best adjusted: TX =0, RX=0，need no offset. Modem select: STM32-DVM/MMDVM_HS-Raspberry pi Hat(GPIO) Antenna: on board two antennas LEDs:on board leds to show status, with status words on shell How to write WiFi detail into the Hotspot: Method 1: Generate WiFi config file, and plug it into TF card. We need a TF reader.Put our TF card into this TF reader and plug this into our computer. Go tohttp://www.pistar.uk/wifi_builder.phpand then fill your WIFI name into the SSID, password into the PSK, click submit. Then the file “wpa_supplicant.conf” is generated. Drag this file into your TF card’s boot path. And plug the card into your hotspot. Power up your hotspot, and wait for 1-2minutes.Then we go tohttp://pi-starand play with the settings. Please keep this in mind that gadget only support 2.4 Gigahertz router, and it does not work with 5.8G router. Method 2: Use tmp WiFi to add new WiFi info into hotspot For convenience, we have placed a tmp WiFi config file in the TF card.Tmp WiFiSSID ism100, password is abc12345. You can make up a tmp wifi by you mobie phone,using the same SSID and the same password. Connect your computer to this tmp wifi, and go tohttp://pi-star, login, use the username pi-star and password raspberry. The hotspot will auto connect to this tmp wifi so. Add network and write you home wifi ssid and psk(make sure the ssid and password is right). Then save and connect. Close the tmp mobile hotspot. Restart the MMDVM hotspot, it will auto connect to your home wifi. After about 2 minutes, you can go tohttp://pi-star, and check the current wifi name. If you need more helps,please go to the websitehttps://youtube.com, and search mmdvm or duplex mmdvm. How to set hotspot toDuplexmode and work: Go to http://pi-star, username: pi-star, password: raspberry (make sure wifi config file has plug into TF card) Specification: Weight: about 15g Material: PCB + electronic components Size: 6*4*2cm (manual measurement) Applicable models: For Raspberry Pi Zero W 0W 2W 3B+ 4B 4B+ Package Included: 1*Duplex MMDVM hotspot board (excluding other products) About Us We accept all payments authorized by eBay. powered by

Price: 44.7 USD

Location: KEARNY, NJ

End Time: 2024-10-11T05:42:55.000Z

Shipping Cost: 0 USD