Fertilizer Injector Dispenser Proportioner 1%-5% 4C-45C Water-driven Injector

Description: Fertilizer Injector Dispenser Proportioner 12-3000L/h 1%-5% 4C-30C Auto Dosing Tools Dosing Device Controllable Dosing Devic This item is a pressure water flow for power, pressure loss is small, without the need for any other power facility, water power the dozer for engine, drive the piston and connecting rod dosing device, the liquid additive direct inhalation and dissolved in water. This device motion in acylinder, the pressure to go out at the same time, the device will be installed at the bottom of the additive in the container through the catheter into the flow in uniform. Moving up and down repeatedly, so as to achieve the additive in a homogeneously continuously added to the water flow effect. The proportional pump can adjust the proportion of the additive in the injected water flow according to the actual situation, so that the additive is evenly added, the specific method is as follows: 1- Loosen the screw and remove the U-shaped adjustment lock from the upper part of the proportional pump. 2- Preset the ratio of liquid additive to water according to the ratio of the water scale on the proportional pump: Counterclockwise adjustment is to increase the specific gravity of the liquid additive. Clockwise adjustment is to reduce the specific gravity of the liquid additive. The percentage on the proportional pump is calculated as the final water output of the proportional pump is 100. 3- Turn the adjuster until the U-shaped adjustment so that the upper hole is inserted into the notch of the proportional pump. 4- Press the U-shaped adjustment lock into the notch of the proportional pump until it is fastened to each other. Specification: Model: Black Proportion range: 1% - 5% Flow range: 12-3000 liters / hour Water flow temperature: 4 degrees -30 degrees Working water pressure:0.3-4 kg Inlet and outlet diameter: 32mm/25mm Standard installation Package List: 1 x Proportional Pump 1 x Bag of Round Gaskets (4Pcs) 1 x Buckle 1 x Capillary Tube 1 x Wrench Notes: 1.Make sure that the container holding the liquid additive is not empty when using the automatic proportional pump! 2.bleed valve: At the beginning of starting the proportional pump, the bleed valve should be pressed down for a few seconds to discharge the existing air inside. There will be a little water flowing out in the process.Immediately after the air is released, close the bleed valve. 3.During installation and use, it is necessary to install filter equipment at the inlet of the proportional pump. 4.If there is an increase in working resistance during use, add lubricant to the piston to increasethe service life. 5.After use, clean the proportional pump with clean water to reduce corrosion and prolong the life of the pump.

Price: 121.59 USD

Location: China

End Time: 2024-12-23T09:08:20.000Z

Shipping Cost: 53 USD